Honda CBR 900 RR Öhlins shock absorber kit Mounting instructions
download Put the motorcycle on a stand so the rear wheel is clear of the ground. Make sure it’s steadily fixed so it will not fall over. 2 Remove the seat (2 screws from below) and loosen the six...
View ArticleHONDA ST1100 SHOCK MOUNTING INSTALLATIOAN AND REMOVAL INSTRUCTIONS
download Works Performance Products, Inc. constructs two types of shocks for the ST1100. Both have an integral reservoir (often referred to as a “piggyback” reservoir). This reservoir increases the...
View ArticleBMW K-SERIES (INCLUDING PARALEVER) SHOCK MOUNTING INSTRUCTIONS
download 1. The shock mounts with the hose towards the rear of the machine, with the shock body at the top and the shaft pointing downward. 2. Take the inside half of the bushing set on the shock eye...
View ArticleHonda Goldwing GL1800 Solid Rear Axle Trike Conversion Installation Manual
download Specifications Overall Width: 57.75″ Overall Length: 108″ Overall Length w/EZ-Steer 109.5 Wheel Base: 71″ Extended 4.5″ At Rear Axel Wheel Base w/EZ Steer 72.5″ Load Capacity: 500 Lb Tire...
View ArticleKTM Enduro Engineering Shock Spring Removal And Installation Instructions
download 1 Place motorcycle on a stand so that the rear wheel is off the ground. 2 Remove the upper shock bolt. (Figure 1) 3 Remove the lower shock bolt. (Figure 2) 4 Remove the shock from the...
View ArticleHARLEY-DAVIDSON SOFTAIL MODELS STEALTH AIR SHOCK MOUNTING
download INSTALLATION 1. Remove the seat, inner fender, and ignition coil cover. Removing the rear wheel assembly is recommended for ease of installation, but not absolutely necessary. Remove the nut...
View ArticleVespa GTS Super Specification
download Gts super 300 ie Gts super 125 ie s 125cc s 50cc Gts 250 ie Gts 125cc LX 125cc LX 50cc 2 stroke Engine Single-cylinder, catalised, QUASAR 4 stroke, 4 valve electronic injection Single-cylinder...
View ArticleHARLEY DAVIDSON LOW REAR SHOCK KIT INSTALLATION MANUAL
download See Figure 3 and Table 1. INSTALLATION Shock Absorbers Perform this installation when the engine is cool. Working on or near the exhaust system when the engine is hot could result in severe...
View ArticleHonda ST 1300 Series Single Shock Supplement
download Check the orientation of the adjuster on the shock body – looking at the top of the shock, the hydraulic line port should be165 degrees (clockwise) from the nitrogen pressure valve (see figure...
View ArticleATK 50MX INSTALLATION AND ADJUSTMENT TIPS
download PRELOAD ADJUSTMENT— On some Works shocks a threaded preload is standard. This allows the adjustment of the ride height of the motorcycle. The preload is changed by turning a threaded nut down...
View Article
More Pages to Explore .....